The robot needs to be maintained regularly. Follow these steps to remove debris from the robot:
1.Turn off the power switch. Remove and empty the dustbin.
2.Clean the primary and high-performance filters.
3.Clean the main brush.
4.Remove and clean the side brushes.5. Remove and clean the main brush.

1.Please check that the app version matches the region version
（1）Turn the machine over, remove the dust box, and check the MAC ID number on the label
（2）North America corresponds to US version：US Region or ALIGW Region
2.Check if the machine is bound by someone else's mobile app
（1）You can log in to the original account to unbind. (Refer to the instructions for use)
（2）Re-networking can force unbundling
（3）Contact the after-sales service, and provide the serial number and registered email address at the same time
3.The machine is not connected to the network
（1）Check whether the distribution network model you selected in the app is consistent with the actual model.
（2）WIFI password must be entered correctly
（3）Cannot use 5G WIFI signal
（4）Check if the router is blacklisted
（5）It is not recommended to use corporate WIFI or public WIFI
4. The phone can't find the machine's hotspot Robot_XXXXX
（1）Check the hotspot name of the machine Robot_XXXX or adh_XXX
（2）Please confirm that your distribution network operation steps are correct. After booting, you need to wait 30 seconds, and then press and hold the button for more than 5 seconds to configure the network.(It is not recommended to distribute the network in or around the charging base)
（3）Try again after shutdown and restart

1.Clean the charging pins on the robot and the charging dock if they are dirty. Try to recharge the robot again.
2.Press the Home button on the remote to let the robot dock itself instead of placing the robot on the dock yourself.

1. The robot will automatically clean the areas that it has missed. Do not move it or block its cleaning route.
2. Because every home setting is different, spatial analysis discrepancy may happen. If the robot hasn’t covered some areas, put it in another spot manually and restart the cleaning cycle.
3. Before using the robot, clear excessive objects on the floor that may block its cleaning path (e.g. cables, slippers, upright fan). The robot cannot clean narrow spaces which are smaller than itself. Rearrange the furniture and settings for better cleaning results.

1. The robot’s battery is low and has entered into search mode for the charging base. The robot's side brushes and wheels will move slower in this mode.
2. Side brushes are jammed by debris. Remove and clean them.

1. Check if the bumper is out all the way. Loosen the screws along the front bumper and tap to restore it to the original position. If nesessary, remove the front bumper, clean and reinstall (make sure not to make screws too tight).
2. Clean the cliff sensors if they are dusty or covered by debris. If problem persists, contact our customer care.

The charging station is placed against the wall, each side is 0.5 meters, and there is no obstacle in the front 1.5 meters. Away from signal interference, such as router TVs,mirrors, windows, etc.

Clean the charging pins of the robot and the charging station with dry cloth. Make sure the side brushes installed correctly.（yellow is left and blue is right）

The wheels maybe blocked with hair, clean it with tools. (if there is still the phenomenon, please contact our after-sales service)

The machine nose wheel is blocked with objects. Remove the nose wheel and cleaning.

After the APP is set successfully, does the machine have a voice response setting successfully? Does the app have set do-not-disturb time? Because the appointment will not work during the do not disturb time